Elmomc SimplIQ Digital Servo Drives-Bell Getting Started Uživatelský manuál stáhnout pdf (Strana 11)

The SimplIQ for Steppers Getting Started & Tuning and Commissioning Guide

MAN-BELGS (Ver. 1.1)

Figure 5: Boot software message

Click Yes to open the windows related to downloading the firmware.

2.1.1 Changing the Communication Parameters

2.1.1.1 Changing the RS-232 Communication Rate and

Parity

First set the desired parameters in the Composer smart terminal:

PP[2] RS-232 baud rate.

5: 115,200;

4: 57,600

3: 38,400

2: 19,200

1: 9,600

0: 4,800

PP[4] RS-232 parity. 0: None

1: Even

2: Odd

Setting PP[2] and PP[4] alone does not change the communication setting, so the

Composer can continue communication with the drive.

Write, for example, PP[2]=5. This is a requirement for a baud rate of 115200/sec.

Next write PP[2]=1. This is a command to accept the new setting. Almost

immediately, you will see:

Figure 6: Communication disconnect message

This is because you changed the baud rate so the communications from the

Composer fail. Click Yes to disconnect, than re-open communication by clicking

Connect.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 93 94

Žádné komentáře

Elmomc SimplIQ Digital Servo Drives-Bell Getting Started Uživatelský manuál Strana 11