Elmomc SimplIQ Analog Servo Amplifiers-Violin Installatio Uživatelský manuál stáhnout pdf (Strana 15)

Violin Installation Guide Installation

MAN-VIOIG (Ver. 2.3)

3-6

Pin #/

Short Form

Function

Remarks

LMRET

Latch mode return Return for Latch mode (LM)

Latch mode Latch mode input

EN+

Enable (+) Positive voltage input of the "Amplifier Enable”

function. To enable operation of the amplifier,

the opto must be switched on by applying

voltage between this pin (+) and pin J2/4 (-).

The opto is isolated from the amplifier. See

Figure 2-1.

 Minimum “ON” voltage: 3 V , current

consumption 0.6 mA.

 Maximum “ON” voltage: 15 V , current

consumption 5.4 mA.

EN-

Enable (-) Negative voltage input of the "Amplifier

Enable” function. Opto isolated from the

amplifier. For details, see pin J2/3.

SORET

Status output

return

Status Outputs Common for AOK, SO1, SO2,

SO3.

Isolated from the circuit common. For details,

see Figure 2-1.

SORET

Status output

return

Status Outputs Common for AOK, SO1, SO2,

SO3.

Isolated from the circuit common. For details,

see Figure 2-1.

AOK

Amplifier OK “Amplifier OK” indication output pin. When the

amplifier is at normal operating conditions this

output is in “active Low “ state. When a failure

occurs this output is changed to “open” state.

Opto isolated, open collector NPN type. See

Figure 2-1.

 Maximum voltage = 30 V

 Maximum current = 8 mA.

 “On” voltage: V

OUT(On)

< 0.8 V

SO1

Status output 1 Status indication output 1. Specification as in pin

J2/7.

SO2

Status output 2 Status indication output 2. Specification as in pin

J2/7.

SO3

Status output 3 Status indication output 3. Specification as in pin

J2/7.

Table 3-5: Connector J2

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Komentáře k této Příručce

Žádné komentáře

Elmomc SimplIQ Analog Servo Amplifiers-Violin Installatio Uživatelský manuál Strana 15

Komentáře k této Příručce

Související produkty a manuály pro Hardware Elmomc SimplIQ Analog Servo Amplifiers-Violin Installatio